# Foboot: The Bootloader for Fomu

Foboot is a failsafe bootloader for Fomu.  It exposes a DFU interface to the host.  Foboot comes in two halves: A Software half and a Hardware half.  These two halves are integrated into a single "bitstream" that is directly loaded onto an ICE40UP5k board, such as Fomu.

## Requirements

To build the hardware, you need:

* Python 3.5+
* Nextpnr
* Icestorm
* Yosys
* Git

Subproject hardware dependencies will be taken care of with `lxbuildenv`.

To build the software, you need:

* RISC-V toolchain

## Building the project

The hardware half will take care of building the software half, if it is run with `--boot-source bios` (which is the default).  Therefore, to build Foboot, enter the `hw/` directory and run:

```
$ python3 foboot-bitstream.py --revision hacker
```

This will verify you have the correct dependencies installed, compile the Foboot software, then synthesize the Foboot bitstream.  The resulting output will be in `build/gateware/`.  You should write `build/gateware/top-multiboot.bin` to your Fomu device in order to get basic bootloader support.

### Usage

You can write the bitstream to your SPI flash.  If you're using `fomu-flash`, you would run the following:

```sh
$ fomu-flash -w build/gateware/top-multiboot.bin
Erasing @ 018000 / 01973a  Done
Programming @ 01973a / 01973a  Done
$ fomu-flash -r
resetting fpga
$
```

Fomu should now show up when you connect it to your machine:

```
[172294.296354] usb 1-1.3: new full-speed USB device number 33 using dwc_otg
[172294.445661] usb 1-1.3: New USB device found, idVendor=1209, idProduct=70b1
[172294.445675] usb 1-1.3: New USB device strings: Mfr=1, Product=2, SerialNumber=0
[172294.445684] usb 1-1.3: Product: Fomu Bootloader (0)
[172294.445692] usb 1-1.3: Manufacturer: Kosagi
```

To load a new bitstream, use the `dfu-util -D` command.  For example:

```sh
$ dfu-util -D blink.bin
```

This will reflash the SPI beginning at offset 262144.

To exit DFU and run the bitstream at offset 262144, run:

```sh
$ dfu-util -e
```

**Note that, like Toboot, the program will auto-boot once it has finished loading.**

## Building the Software

Software is contained in the `sw/` directory.